Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Air shroud
Identify the air shroud highlighted in blue
Holding the touch points, lift the cooling shroud away from the system.
Backplane Cover
Identify the backplane cover highlighted in blue
Slide the backplane cover in the direction of the arrows marked on the backplane cover.
Lift the backplane cover away from the system.
Control panel -Left
Identify the control panel highlighted in blue
Disconnect the control panel cable from the system board connector.
Open the cable retention plastic clip.
Unoute the control panel cable from the side wall of the system.
Remove the screw that secure the cable cover.
Remove the cable cover securing the left lontrol panel cables
Remove the screws that Secure the control panel to the system.
Holding by the sides, remove the left control panel assembly away from the system.
Install
Control panel -Left
Identify the control panel location highlighted in blue
Route the control panel cable through the side wall of the system.
Align the left control panel assembly with the slot and slide into place
Connect the control panel cable to the system board connector
Close the cable retention plastic clip.
Install the screws that secure the control panel assembly to the system
Install the cable cover to secure the left control panel cables
Install the screw that secure the cable cover.
Backplane Cover
Identify the backplane cover location highlighted in blue
Align the tabs on the backplane cover with the guide slots on the system.
Slide the backplane cover toward the front of the system until the cover locks into place.
Air shroud
Identify the cooling shroud location highlighted in blue
Align the slot on the air shroud with the standoff on the chassis.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.